Omega 1000 Juicer: Assembly, Dissembly and Cleaning

Assembling Omega 1000 juicer is breeze. You will begin it with positioning the bowl on the motor base housing. Place it is in the middle of the two raised projections with the sprout facing you. Now place the strainer basket inside the bowl. The strainer should sit on the bowl in a manner so that it rest flat on the platform center hex nut. Now the cutter blade has to go over the hex nut with its teeth up. Now tighten the clutch nut tight. You can now insert the filter liner which will ease the hassle of cleaning. Now place the cover on the bowl with the chute at its rear. Ensure that everything is in place putting on the latch arms. Put the plunger in the opening of the chute.

Dissembling the centrifugal juicer is as easy as assembling it. Remove the plunger. Release the latch arms. Remove the cover. Unscrew the clutch nut by rotating it clockwise. Lift the cutter blade and remove the blade and the bowl.

Juicing Tips

There are some helpful hints for juicing with Omega 1000 juicer. Before you begin juicing ensure that the machine is running with its full speed. Do not push the produce down the chute with much force. A steady push will work best.  If your juicer is vibrating much then a little push with lounger will bring it back to balance.

The juicer has a wide chute. So there is no need to cut fruits and vegetables in small pieces to enable them pass through it. It can take in whole fruits.

When you are making combination juicer, alter one fruit or vegetable with other. This will be effective for a better juicing. When juicing stringy greens like wheatgrass, always roll the produce into a ball. Follow the greens with produces like carrots. The force of the latter with effectively extract juice from the greens.

When you are juicing softer fruits like tomatoes do not use the filter. Pause before inserting each vegetable. This will give the juicer enough time to extract juice through the strainer basket. When juicing citrus fruits, alter them with firmer produces to get better results. Always de-seed the grapes or peel the tomatoes before juicing.

Allow the juicer to run one or two time after juicing to extract the juice from the pulp. Always select fresh, crispy fruits for juicing. Clean fruits and vegetables before juicing.

Cleaning

 After dissembly, wash the juicer parts with cold water. You can use a mild detergent. Parts like bowl, plunger, cover and clutch nut do not require to be rinsed much. You can wash the cutter blade under running water. You can use a stiff brush to remove the food residue.

You clean the juicer parts in the dishwasher. But do not put the plunger and top in the dishwasher. To remove the pulp from the strainer basket you can make use of your hands. If the pulp is stuck dry run the juicer. You can towel dry the juicer parts before assembling again. Due to repeated washing you will get minerals stains on the juicer. You can immerse the juicer parts in water mixed with eight tablespoons of cascade or similar dishwasher detergent per gallon of water. Do not use any lubrication for the machine.